Westcoat WP-81 Acrylic Polymer Cement Modifier | 5 Gallon
WP-81 used in base coat (4:09), slope application (4:59), and texture coat (7:26)
About
WP-81 is primarily used as an additive to Westcoat cement products such as TC -1, 2, 3, 4 or 5 so that they can be used to waterproof decks, resurface or patch concrete and for a variety of exterior decorative concrete treatments.
Specs
- Solids Content: 47% by weight
- 60% Gloss (4mil dry film): 85
- Viscosity: 150cps
- Flash Point: >200° (TCC)
- Maximum VOC: 0 grams per liter
- Color: Milky white, dries clear
Instructions
Applying Product
For Small Patches
- Cut or chip open cracks or voids and clean. Mix one gallon of WP-81 or WP-82 with 1 bag of Westcoat Cement such as TC -1, 2, 3, 4 or 5.
- Combine the WP-81 or WP-82 and cement and add water to desired consistency.
- Mix thoroughly with a low rpm drill motor.
- Place the material into the area to be patched and smoothed or finished to desired effect using a trowel or float. (For larger patches see Concrete Patch System Specification Sheet).
As a Stucco Additive
- WP-81 or WP-82 is an excellent additive to most stucco products.
- The stucco will bond better, weather better with reduced cracking and be more waterproof.
- When adding to stucco, simply mix 1-2 quarts of WP-81 or WP-82 per 90lb. bag of stucco.
- Add water to achieve desired consistency.
- Mix thoroughly with a low rpm drill motor.
- WP-81 or WP-82 will make the stucco a bit stickier and will cause it to cure more rapidly.
Freshen up Concrete
- Combine ½ gallon of WP-81 or WP-82 and up to 1 gallon of water with 1 bag of TC-5 Grout Texture Cement to achieve the desired consistency.
- See complete Texture-Crete Broom On System Specification Sheet.
As a Decorative or Waterproof Coating
- Combine the WP-81 or WP-82 as described in the System Specification sheets for the Westcoat ALX™ waterproof decking system and Texture-Crete® concrete resurfacing system.
- See ALX™ and Texture-Crete® System Specification Sheets for complete instructions.
